Grab Bar Accessory, The WingIt and Accessories

Grab Bar Accessory, The WingIt and Accessories, Choose Size

Part # A1 220-232 (Standard 4" Long Screw)
Part # A1 220-232-05 (5" Long Screw)
Part # A1 220-232-06 (6" Long Screw)

The Worlds Strongest Fastener for Grab Bars. Allows for Installation of Grab Bars into Almost Any Wall!

The WingIt™ can reduce the cost of retrofitting a grab bar up to 70% while allowing for freedom of placement in both new and existing construction. Dry wall, tile, and acrylic or fiberglass tub surrounds are some of the walls that the WingIt™ can be utilized. Freedom of design: WingIts™ allow for grab bar installation to occur at any time during the building process. Architectural changes or lack of communication between the building trades will not affect the grab bar installation process. There is not any reinforcement to miss, installation of the WingIts™ can be done after the bathroom fixturing has been set.

Features:

› Waterproof seal - Incorporates 3M® VHB Tape

› No blocking or studs needed

› No need to tear open and reconstruct walls

› Can be installed in all framed walls

› In sheet rock and ceramic tile, WingIts hold up to 1,000 lbs

› Meet and exceed all building codes and ADA Requirements

› Only legal alternative to 2x10 blocking
› Sold as per eaches, not as a pair.

Note: Below is a list of grab bars that this item is NOT compatible with and can NOT be used with the following part numbers.

220-220	220-226
220-221	220-227
220-222	220-228
220-223	220-229
220-224	220-230
220-225

Note: Below are a few accessories that would better help you install your item, you can add to your cart.

Note: Please choose your screw length below for option bar.